The Monoprice controller will take power from the Rasperry Pi over USB and appear to be operational even if the main power supply is turned off. If the printer will not heat, check the power switch on the power supply.
Size | 210x210x200mm |
---|---|
Extruder | Single 0.4mm |
Drive | Direct |
Heated Bed | Yes |
Resolution | 100 microns (0.1mm) |
Filament | 1.75mm |
Materials Supported | PLA, ABS |
Formats | |
Software | Cura, Slic3r |
Connections | Octopi @ http://10.3.0.75 |
MakerSmiths | Mike O'Brien |
---|---|
Manual | Makerbot Replicator 2 User Manual |
OEM Support | https://support.makerbot.com/troubleshooting/makerbot-replicator-2 |
OEM Parts | https://store.makerbot.com/parts-accessories/ |
Item | Notes | Cost | Source |
---|---|---|---|
BuildTak build surface | 6.5"x6.5" can be cut down to 5 1/8" x 6 1/4" | $20 (3) | MatterHackers |
Printer Parts | Thor 3D |