This checklist is not a substituent for proper training on the usage of the machine.  You are required to take an orientation and sign off class to use the Tormach.  Any un-authorized usage of this machine means that any damage to the machine is the responsibility of the un-authorized user.  This includes repair and replacement of any damaged parts.  This can be upwards to 25k if the machine is majorly damaged.

Machine Setup

•  Check coolant level on the back of the machine.  If coolant is needed mix 4010 coolant stored in the bottom cabinet 4 cups water to 1/2 cup coolant.
• Turn on Air compressor.  Red power knob on the side of the air compressor
• Pull the oil choke out.  Note this in the log book.  This really only needs to be done every 8 hrs, so check the log book first
• Power on machine.  Power knob is on the right had side of the machine.  Reach from the front of the machine
• Once path pilot is up
  • Un estop the machine
  • Push green reset button on pendant
  • Select reset in path pilot
  • Ensure vise handle it in center hole 
  • Select RefX, RefY, RefZ

You are now ready to either run a conversational program or execute a gcode program created using fusion or other CAM program

Machine Usage

Machine Shutdown