| Table of Contents | ||
|---|---|---|
|
The settings provided below are for the Haotian 100W Fiber Laser at MSP. This laser has a JPT source, and we have 100mm, 160mm, and 290mm lenses available for use.
Remember to use appropriate safety gear and to clean up after yourself.
...
Aluminum Settings
Car Badge - Deep Engraving Aluminum | |||
|---|---|---|---|
Material Type - Aluminum. Non specific alloy. Lens = 160mm Focus = Regular Material Thickness = TBD Notes = Work Material put on top of heatsink | |||
Layer 1 - Engraving | |||
Sub Layer 1: Engraving Deep | |||
| Speed = 1500 mm/sec | Frequency = 75 KHZ | ||
| Power = 100% | Q-Pulse = 200 | ||
| Mode= Fill | Global Passes = 2 | ||
| Bi-Directional Fill and Cross Hatch = ON | |||
| Line Interval = 0.025 | |||
| Scan Angle = 45 | |||
| Number of Passes = 5 | |||
| Angle Increment = 0 | |||
| Auto Rotate = ON | Flood Fille = Off | ||
| Wobble = OFF | Fill All Shape at Once = Yes | ||
| Step = N/A | Fill Groups Together = No | ||
| Size = N/A | Fill Shapes Individually = No | ||
Sub Layer 2: Engraving Cleanup | |||
| Speed = 3000 mm/sec | Frequency = 37 KHZ | ||
| Power = 15% | Q-Pulse = 200 | ||
| Mode= Fill | Global Passes = 2 | ||
| Bi-Directional Fill and Cross Hatch = OFF | |||
| Line Interval = 0.05 | |||
| Scan Angle = 0 | |||
| Number of Passes = 2 | |||
| Angle Increment = 0 | |||
| Auto Rotate = ON | Flood Fille = Off | ||
| Wobble = OFF | Fill All Shape at Once = Yes | ||
| Step = N/A | Fill Groups Together = No | ||
| Size = N/A | Fill Shapes Individually = No | ||
Layer 2 - Cut Out | |||
Sub Layer 1: Cut Through | |||
| Speed = 3000 mm/sec | Frequency = 37 KHZ | ||
| Power = 15% | Q-Pulse = 200 | ||
| Mode= Fill | Global Passes = 2 | ||
| Number of Passes | |||
| Perforation Mode = Off | |||
| Perforation Mode - Cut = N/A | |||
| Perforation Mode - Skip = N/A | |||
| Wobble = On | |||
| Wobble - Step = 0.100 | |||
| Wobble - Size = 0.350 | |||
| Kerf offset (mm) = 0.00 | |||
...