...
- 3D Printing
wet Swiffer the rubber tiles
- Help brainstorm the best way to make the style legs we want
- CNC curved tabletop pieces
- cut down veneered pieces using the provided diagrams for table tops and shelves for the room.
Cosplay:
- Check the cosplay channel to see if there are any outstanding tasks
Printmaking:
Sewing & Craft Area:
Main Room:
- Move the TV from next to the laser cutter to the back wall where the plug is on the wall.
- Please do not start until the IT committee chair is available since we will need to reconfigure the routers as well.
- Patch up the wall where the TV used to be.
- Supplies for this will be on the tall table in the main room.
- Switch the table next to the laser copier with the Roland UV printer
- please don't start unless you have either UV printer steward with you!!! Jessee and John Carter will be around.
- Switch the UV printer computer stand and the laser copier
- Both of these need to be attached to ethernet, so please make sure the IT committee chair is around before doing this. Scott Silvers should be around
- once the table is where the Roland UV printer used to be, move the sublimation printer, computer, heat presses, and accessories to that table.
- The table that once held sublimation will now be a workbench where we will be putting pegboard behind it and the screwdrivers, spinning black holder, etc.
sweep and vacuum
- empty trash cans. Please be careful, they are pretty full.
dust and wipe down all glass surfaces
including computer screens, the top of the laser cutter, the UV printer, etc.
- Do you know how to use the Cricut or vinyl cutter?
- Jessee has some files that need to be cut out of vinyl and placed around the building.
- files will be ready to go after 11am
- Move the TV from next to the laser cutter to the back wall where the plug is on the wall.
New Classroom
- consolidate resin printers to one table (I'd prefer the one on the right)
- deconstruct the table on the left if possible
Metal Shop
- Dust/Wipe Down any equipment covered in red powder-coating dust.
- patch a large hole in the corner near the powder coating.
- empty trash in blue bucket (but leave large blue bucket!) and trash take out the box full of trash next to it too. If you are unsure if it’s the right box, please ask Jessee first! If there is no room for it outside, we will need to discuss a trash dump run.
Woodshop
vacuum floor and around machines
empty the trash cans
- If you can reach, vacuum on top of the dust collection tubes
Woodturning
vacuum floor and around machines
Bathrooms
wipe down the sinks
wipe down the toilets
Swiffer the floors
empty the trashcans
...