...

Motion: Allocate $350.00 from the Equipment Reserve Fund to build and test a Raspberry Pi solution as a Kiln Controller.  Funds will be expended by May 30 with any remaining funds returned to the Equipment Reserve Fund.

Second:

Vote: 

NB4: Replacement Wiring for the Powder Coat Oven (Jim for Dave)

 Issue:   Wiring for the Powder Coat oven was not of sufficient gauge.  This was discovered as the result of and overheat event (we hope the oven was not damaged).  It was wired with #8 wire on a 50 amp breaker and needs #4 wire on a 70 amp breaker.  The 50 amp circuit and outlet was part of the original wiring to the Paint Booth area.  We do not know who put a plug on the Oven and plugged it into the outlet.  In any event, we need to run a new circuit of the proper capacity (and copper is very expensive right now)

Solution: Run a new 70 amp circuit in conduit with #4 wire and disconnect box for the Powder Coat Oven.  We need the Circuit Breaker, Wire, Conduit, and a 70 amp disconnect box.

Relevance to Tax Exempt Status: None

Motion: Allocate $1,000.00 from the Equipment Reserve Fund to wire the new circuit.  Funds will be expended by May 30 with any remaining funds returned to the Equipment Reserve Fund.

Second:

Vote: 

Open Discussion

Executive Session

...