Description
Instructions
Software
For best results, use Ultimaker Cura with the following settings:
Go to Settings->Add Printer
Under Other select Prusa i3 Mk2. Change Printer Name to something meaningful, such as Monoprice IIIP Select.
Click Add Printer
Turning it On
The power switch is on the rear of the printer. Note that the controller may be on, as it draws power from the USB, even if the printer is off.
Loading and Unloading Filament
...
The Monoprice controller will take power from the Rasperry Pi over USB and appear to be operational even if the main power supply is turned off. If the printer will not heat, check the power switch on the power supply.
Specifications
Size | 210x210x200mm |
---|
Extruder | Single 0.4mm |
---|
Drive | Direct |
---|
Heated Bed | Yes |
---|
Resolution | 100 microns (0.1mm) |
---|
Filament | 1.75mm |
---|
Materials Supported | PLA, ABS |
---|
Formats |
---|
| Support
Makerbot Replicator 2 User supportmakerbottroubleshootingmakerbotreplicator2storemakerbotparts-accessories/ Parts and Supplies
| | | |
---|
BuildTak build surface | 6.5"x6.5" can be cut down to 5 1/8" x 6 1/4" | $20 (3) | MatterHackers |
Printer Parts |
|