Description
Instructions
Turning it On
Leveling the Bed
Loading and Unloading Filament
Printing
Cleaning
Troubleshooting
Hot end will not heat
The Monoprice controller will take power from the Rasperry Pi over USB and appear to be operational even if the main power supply is turned off. If the printer will not heat, check the power switch on the power supply.
Specifications
Size | |
---|---|
Extruder | Single 0.4mm |
Drive | Direct |
Heated Bed | Yes |
Resolution | 100 microns (0.1mm) |
Filament | 1.75mm |
Materials Supported | PLA, ABS |
Formats | |
Software | Cura |
Connections | Octopi @ http://10.3.0.75 |
Support
MakerSmiths | Mike O'Brien |
---|---|
Manual | Makerbot Replicator 2 User Manual |
OEM Support | https://support.makerbot.com/troubleshooting/makerbot-replicator-2 |
OEM Parts | https://store.makerbot.com/parts-accessories/ |
Parts and Supplies
Item | Notes | Cost | Source |
---|---|---|---|
BuildTak build surface | 6.5"x6.5" can be cut down to 5 1/8" x 6 1/4" | $20 (3) | MatterHackers |
Printer Parts | Thor 3D |