You are viewing an old version of this page. View the current version.
Compare with Current
View Page History
« Previous
Version 3
Next »
Aluminum Settings
Deep Engraving Aluminum - 160mm Lens |
|---|
Layer 1 - Engraving |
Sub Layer 1: Engraving Deep |
| Speed = 1500 mm/sec | Frequency = 75 KHZ |
| Power = 100% | Q-Pulse = 200 |
| Mode= Fill | Global Passes = 2 |
| Bi-Directional Fill and Cross Hatch = ON |
| Line Interval = 0.025 |
| Scan Angle = 45 |
| Number of Passes = 5 |
| Angle Increment = 0 |
| Auto Rotate = ON | Flood Fille = Off |
| Wobble = OFF | Fill All Shape at Once = Yes |
| Step = N/A | Fill Groups Together = No |
| Size = N/A | Fill Shapes Individually = No |
Sub Layer 2: Engraving Cleanup |
| Speed = 3000 mm/sec | Frequency = 37 KHZ |
| Power = 15% | Q-Pulse = 200 |
| Mode= Fill | Global Passes = 2 |
| Bi-Directional Fill and Cross Hatch = OFF |
| Line Interval = 0.05 |
| Scan Angle = 0 |
| Number of Passes = 2 |
| Angle Increment = 0 |
| Auto Rotate = ON | Flood Fille = Off |
| Wobble = OFF | Fill All Shape at Once = Yes |
| Step = N/A | Fill Groups Together = No |
| Size = N/A | Fill Shapes Individually = No |
Layer 2 - Cut Out |
Sub Layer 1: Cut Through |
| Speed = 3000 mm/sec | Frequency = 37 KHZ |
| Power = 15% | Q-Pulse = 200 |
| Mode= Fill | Global Passes = 2 |
| Number of Passes |
| Perforation Mode = Off |
| Perforation Mode - Cut = N/A |
| Perforation Mode - Skip = N/A |
| Wobble = On |
| Wobble - Step = 0.100 |
| Wobble - Size = 0.350 |
| Kerf offset (mm) = 0.00 |