This checklist is not a substituent for proper training on the usage of the machine. You are required to take an orientation and sign off class to use the Tormach. Any un-authorized usage of this machine means that any damage to the machine is the responsibility of the un-authorized user. This includes repair and replacement of any damaged parts. This can be upwards to 25k if the machine is majorly damaged.
Please print this checklist and fill it out with each usage
Date:_______________________________________________________
User:_______________________________________________________
Materials Cut:________________________________________________
Tools Used: (Others Not Listed Below)____________________________
|
|
|
|
|
|
Total Machine Time:___________________________________________
Folders Created:______________________________________________
Do you need to keep the folders Y/N
Date Folders Can be removed: (No more then 30 days)______________
Machine Setup
- Check coolant level on the back of the machine. If coolant is needed mix 4010 coolant stored in the bottom cabinet 4 cups water to 1/2 cup coolant.
- Turn on Air compressor. Red power knob on the side of the air compressor
- Pull the oil choke out. Note this in the log book. This really only needs to be done every 8 hrs, so check the log book first
- Power on machine. Power knob is on the right had side of the machine. Reach from the front of the machine
- Once path pilot is upback
- Un estop the machine
- Push green reset button on pendant
- Select reset in path pilot
- Ensure vise handle it in center hole
- Select RefX, RefY, RefZ
You are now ready to either run a conversational program or execute a gcode program created using fusion or other CAM program
Machine Shutdown