Learning CNC Resources

For introductory and general guidance for CNC: Learning CNC Resources

Red Tool Training Class Slides

Checklist

Long

Short

GCode explained

Instructions

Surfacing

Milling Rigid Foam

Thanks to Jonathan White :

Think of the sheets of pink/green insulation foam you can buy at the blue or orange hardware store, I did a small project on the EBF yesterday.  After angsting about it for awhile, I gave it a shot and 10,000RPM, 150IPM, cutting the full 3/4 deep cut in one pass with an upcut 1/4 endmill, conventional milling, worked perfectly - crisp edges, no burning.  The stepover was only 40% which could have been increased to reduce cut time.  The only issue was that the bristles on the EBF dust hood scratched the top surface a bit, but this was a functional project so no big deal.  That could be avoided by raising the dust hood a little bit.

?

Clamping System

Video of the clamping system: https://drive.google.com/file/d/1OujpILwkB9RfiwdSSosVxea8PkIbwL0b/view?usp=drive_link

Clamping System on Thingiverse: https://www.thingiverse.com/thing:6048725

Troubleshooting

PDF

Removing a "Stuck Tool"

https://drive.google.com/file/d/15TGpqI7k18v7Pyn-Bp5Rz_cEk6rU7u-w/view?usp=sharing

Air Compressor Timer

The instructions for checking that the timer attached to the air compressor is set correctly are in the instruction sheets.  Below is a short video on checking the timer:

https://drive.google.com/file/d/149MomTHKG85XCgpbQfVBixU0eYvqNv2a/view?usp=drive_link