Description
Instructions
Software
For best results, use Ultimaker Cura with the following settings:
Go to Settings->Add Printer
Under Other select Prusa i3 Mk2. Change Printer Name to something meaningful, such as Monoprice IIIP Select.
Click Add Printer
Turning it On
The power switch is on the rear of the printer. Note that the controller may be on, as it draws power from the USB, even if the printer is off.
Leveling the Bed
Loading and Unloading Filament
Printing
Cleaning
Troubleshooting
Hot end will not heat
The Monoprice controller will take power from the Rasperry Pi over USB and appear to be operational even if the main power supply is turned off. If the printer will not heat, check the power switch on the power supply.
Specifications
| Size | 210x210x200mm |
|---|---|
| Extruder | Single 0.4mm |
| Drive | Direct |
| Heated Bed | Yes |
| Resolution | 100 microns (0.1mm) |
| Filament | 1.75mm |
| Materials Supported | PLA, ABS |
| Formats | |
| Software | Cura, Slic3r |
| Connections | Octopi @ http://10.3.0.75 |
Support
| MakerSmiths | |
|---|---|
| Manual | Monoprice Select Plus Manual |
| OEM Support | https://monopricesupport.kayako.com/category/2-3d-printing-videos |
| OEM Parts | https://www.monoprice.com/pages/3d_printers |
Parts and Supplies
Item | Notes | Cost | Source |
|---|---|---|---|
| BuildTak build surface | 6.5"x6.5" can be cut down to 5 1/8" x 6 1/4" | $20 (3) | MatterHackers |
| Printer Parts | Thor 3D |