This checklist is not a substituent for proper training on the usage of the machine. You are required to take an orientation and sign off class to use the Tormach. Any un-authorized usage of this machine means that any damage to the machine is the responsibility of the un-authorized user. This includes repair and replacement of any damaged parts. This can be upwards to 25k if the machine is majorly damaged.
Machine Setup
- Check coolant level on the back of the machine. If coolant is needed mix 4010 coolant stored in the bottom cabinet 4 cups water to 1/2 cup coolant.
- Turn on Air compressor. Red power knob on the side of the air compressor
- Pull the oil choke out. Note this in the log book. This really only needs to be done every 8 hrs, so check the log book first
- Power on machine. Power knob is on the right had side of the machine. Reach from the front of the machine
- Once path pilot is up
- Un estop the machine
- Push green reset button on pendant
- Select reset in path pilot
- Ensure vise handle it in center hole
- Select RefX, RefY, RefZ
You are now ready to either run a conversational program or execute a gcode program created using fusion or other CAM program
Machine Usage
Machine Shutdown