| Table of Contents | ||
|---|---|---|
|
Learning CNC Resources
For introductory and general guidance for CNC: Learning CNC Resources
Red Tool Training Class Slides
| View file | ||||
|---|---|---|---|---|
|
Checklist
Only -Long
and Short| View file | ||
|---|---|---|
|
|
Short
| View file | ||||
|---|---|---|---|---|
|
GCode explained
| View file | ||
|---|---|---|
|
|
Instructions
Surfacing
| View file | |
|---|---|
|
|
Surfacing Instructions
| View file | ||||
|---|---|---|---|---|
|
Milling Rigid Foam
Thanks to Jonathan White :
Think of the sheets of pink/green insulation foam you can buy at the blue or orange hardware store, I did a small project on the EBF yesterday. After angsting about it for awhile, I gave it a shot and 10,000RPM, 150IPM, cutting the full 3/4 deep cut in one pass with an upcut 1/4 endmill, conventional milling, worked perfectly - crisp edges, no burning. The stepover was only 40% which could have been increased to reduce cut time. The only issue was that the bristles on the EBF dust hood scratched the top surface a bit, but this was a functional project so no big deal. That could be avoided by raising the dust hood a little bit.
?
Clamping System
Troubleshooting
Removing a "Stuck Tool"
Video of the clamping system:
https://drive.google.com/file/d/15TGpqI7k18v7Pyn-Bp5Rz_cEk6rU7u-w1OujpILwkB9RfiwdSSosVxea8PkIbwL0b/view?usp=sharing
| Table of Contents | ||
|---|---|---|
|
Learning CNC Resources
For introductory and general guidance for CNC: Learning CNC Resources
EBF CNC Red Tool Training Class Slides
| View file | ||||
|---|---|---|---|---|
|
Troubleshooting
| View file | ||
|---|---|---|
|
| View file | ||||
|---|---|---|---|---|
|
EBF Troubleshooting
View file
|
EBF Checklist, GCode explanations, and other instructions.
|
Surfacing Instructions
| View file | ||||
|---|---|---|---|---|
|
Removing a "Stuck Tool"
https://drive.google.com/file/d/15TGpqI7k18v7Pyn-Bp5Rz_cEk6rU7u-w/view?usp=sharing
Air Compressor Timer
The instructions for checking that the timer attached to the air compressor is set correctly are in the instruction sheets. Below is a short video on checking the timer:
https://drive.google.com/file/d/149MomTHKG85XCgpbQfVBixU0eYvqNv2a/view?usp=drive_link
EBF 'Con-treu-leur' (wiring diagram)
...
| View file | ||||
|---|---|---|---|---|
|
EBF Manual
...